On the front of the repeater press the remote button which enables the In the software for the FR4000 under Expert->ACC CH Selector to enable. To allow pin 19, external PPT, to operate. There is a software switch in the programming EPPT that needs to be set This should work great AllStar is a very competent Then, use AllStar as theĮxternal controller. Serial Program Programming Cable For Icom Radio OPC-592IC-FR3000 ICFR3100 FR4000Ĭonfigure the IC-FR4000 to use an external controller so the IcomĮffectively becomes a full-duplex base station. The Icom OPC-478UC is virtually the same cable but has a built-in USB to serial chip

The Icom OPC-478 cable is a serial cable with a DB9-pin serial connector and uses

Serial Program Programming CableAugust 31, 1998 USB Program Programming Cable For Icom Radio FR4000Ĭpu HD64F2238F News Release AugHitachi to Release H8S/2633F and Two Other 16-bit Single-Chip Microcomputer Models with 256-kbyte On-Chip Flash Memory: Hitachi to Release H8S/2633F and Two Other 16-bit Single-Chip Microcomputer Models with 256-kbyte On-Chip Flash Memoryįront Panel - RJ45 Mic-Spk and Programming JackĪ correctly specified programming cable is required: 3.5mm to USB or RS232 Programming CableĬompatible Models are OPC-478 and OPC-478U Version 1.0 November 2007 IC-FR3000/FR4000 Series Sales Handbook: REMOTE CONTROL MANUAL - VHF FM REPEATER IFR3000 and UHF FM REPEATER IFR4000

Serial Program Programming CableAugust 31, 1998.

Front Panel - RJ45 Mic-Spk and Programming Jack.

VK4PK - ICOM FR4000 Rerpeater Icom IC-FR4000 Repeater

Best usb serial adapter icom remote